josephfowler9698 Posted March 8, 2022 Share Posted March 8, 2022 Hi recently done a g28 sensor and rms on a 2014 crafter 2.0 using the special pressing/ aligning tool. Starts and runs bang on until you drive it. Getting p0322 no crank signal. Where did I go wrong? Cheers Quote Link to comment Share on other sites More sharing options...
Volkswagen Owners Club Posted March 16, 2022 Share Posted March 16, 2022 Does it cut out when you start to drive? Installation looks fine, except for there looks like another dimple a few degrees to the left of the top mark which may be BTDC rather than TDC mark? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.