Technical Help
Give and receive technical help for your car
79 topics in this forum
-
-
hi ive got a vw transporter 1.9 tdi 2006 engine code brr and need a vacuum pump can someone please tell me what the difference is between 038145209 and 038145209P so it just the letter P at the end as it looks the same as mine any info would be great, is it just a different variant thanks
-
- 0 replies
- 653 views
-
-
Hi all, I've purchased a passat b6 bkp dsg with no reverse gear. When I first got the car it worked after being parked up for a couple of months. I've scanned it with Carly I will attach the errors. As since the car has lost reverse again and has a error stored in the gearbox and something to do with solenoid 3. I wanted to know if there is anything that can cause this I.e low oil or a service may cure. Or would you recommend removing the unit and repair?
-
- 1 reply
- 859 views
-
-
Hi guys, got a mk8 with the above fault. It was in a smash but all error codes cleared new seatbelts etc so no airbag light or anything. Now digital climate control is not working due to above fault. I am also getting fault code b109ef0. Does anybody know the standard coding for the hvac fault so I can overwrite with vcds? Any help would be appreciated Thanks
-
- 0 replies
- 7.3k views
-
-
Hi guys. 2mths ago my bke engine siezed after the turbo blew and emptied the sump in less than 300 yards. I have installed a bkc engine out of a 55 plate A3. "my car is an 08 plate touran. The garage are having problems as the car is stuck in limp mode. Its showing a crank senor error. Due to this the car is hard to start and when started will not go over 3000rpm. Is it because this older type engine uses a crank sensor the tourans computer is not compatable with or cannot understand the reading the crank sensor is sending back to it? Really stuck in a rock and a hard place here as they dont know what to do next. The car had a stage 1" tune months before the turbo failure…
-
- 1 reply
- 849 views
-
-
I got a Polo 1.2 tdi Bluemotion. The car starts with one kick, doesn't miss, idel perfectly, but got no power, what can be the problem
-
- 1 reply
- 1.2k views
-
-
My VW Eos Sport TSI When pulling a way fast there is a delay and then suddenly springs into action it's a bit hairy if pulling away on a roundabout ? Thanks Mike
-
- 1 reply
- 1.8k views
-
-
The wireless carplay in our Polo is very convenient, except that when my wife and I both get in the car, we don’t seem to be able to control which phone connects to CarPlay. How do we control who connects, or swap from one to the other? Currently we are switching off Bluetooth on one phone before starting the engine
-
- 1 reply
- 1.3k views
-
-
I purchased a VW Sharan 1.4TSI 2011 via a private sale in July this year. I needed a 7-seater with the imminent arrival of twins (we already have 3 kids!) and after a lot of research decided that the Sharan fitted the bill. So basically, I have a problem with the car now where there are amber warning lights on the dashboard for ABS and ESP plus stop/start & autohold have stopped working. I initially took the car to an independent VW garage who told me there was a coding issue and they couldn't recode and recommended I take it to the main VW dealer. The VW dealer was also confused and sent details to their technicians in Germany - they finally came back and tol…
-
-
- 2 replies
- 1k views
-
-
Hi All, I’m new to the forum but on my 5th VW. The latest being a rather lovely kingfisher blue Arteon Shooting Brake. Loving the car but I have an issue with the adaptive cruise and the road sign system. Basically when the cruise is on and it reads a sign, let’s say 50mph for example, it adjusts the speed to 31mph (50kmh) which is annoying at best and borderline dangerous at times. Is there a simple fix for this that I’m missing or is it a full dealer job? Thanks in advance Mick
-
- 1 reply
- 1k views
-
-
Hi I have a 2007 VW golf plus with 120000 miles on the clock. The clutch pedal is on the floor. I can pull it back into position and it initially seems OK. I can place it into gear and it starts to drive. If I try to use the clutch pedal again it goes to the floor and does not come back up and I cannot disengage the gear. Is it a master or slave cylinder problem
-
- 0 replies
- 1.7k views
-
-
New to this but I’ve had to replace my 4 injectors as the their either dead or near to death as their the cars on 174000miles. When I looked at the part number on my old injectors, they were of 04L not 03L. The picture is of the injector which came out my car. I rang a breakers yard and they told me it’s the wrong injector and that my code is 03L. I’ve ordered a new set of injectors with which are the same as the picture below but I’m concerned due to also checking online that they are not meant for mine but were working perfectly for the however long I’ve owned the car. Any help would be appreciated thanks.
-
- 1 reply
- 3k views
-
-
I have a 2016 Golf GTD, I am trying clarify if apple CarPlay is a standard feature? If not how do you get the CarPlay feature installed?
-
- 1 reply
- 3k views
-
-
Hi recently done a g28 sensor and rms on a 2014 crafter 2.0 using the special pressing/ aligning tool. Starts and runs bang on until you drive it. Getting p0322 no crank signal. Where did I go wrong? Cheers
-
- 1 reply
- 3.4k views
-
-
Hello, I am looking for a 3-pin reverse light switch for a 1998 Sharan 1.8 T petrol. The switches I have seen so far are all 2-pin. Any wisdom on this issue, please?
-
- 1 reply
- 2.3k views
-
-
I have a 2009 VW polo with a battery that runs flat if I haven’t turned the engine over for about 4 days. It’s been doing this for about 3 years years now. In the past I didn’t drive it much and mostly short journeys but since the problem started I’ve been driving it at least twice a week for about 45 mins each time. I have RAC cover so each time it’s flat they run checks on the battery and almost every time the result is replacement battery needed. My cover provides replacement batteries so there’s no additional cost but it does mean I’m getting about 3 new batteries a year. I’ve had the car checked multiple times for a drain, none can be found and the alternator is fine…
-
- 1 reply
- 1.6k views
-
-
Hi, As per the title my wife 07 eos developed a weird issue on a long trip last week. Suddenly whilst driving the check engine light came on and the interior fan started going up and down with the accelerator pedal. I took it in to have any fault codes read and it showed up a bunch if codes...all 4 glow plugs, plus a pressure leak/ swirl flap fault? When the codes were cleared they have not returned BUT the interior fan is still coming in when accelerating and speeds up and slows down with the accelerator. This is making me consider a possible wiring issue with a possible cut somewhere in the harness causing a short and meaning that the codes may even not…
-
- 0 replies
- 1.2k views
-
-
Anyone managed to install a dual Climatronic heater loom with dash in situ ? Some prat cut the far left plug loom that fits into back of my Climatronic unit (there are three separate plugs in all) during a dash swap and reinstall. I also checked either side of the dash for the left & right temperature sensors and there were no plug loom attached to the sensors and I could not find loom, I had hoped it had fallen back. As a result there’s no control over recirculating flap, no control over left & right temperature flap motors, can’t change direction of air flow to different vents or floor & no AC. However the rest of the functions work that corres…
-
- 0 replies
- 1.3k views
-
-
Hi all, Just bought myself a 2009 Touareg V6 Altitude model that has the RNS510 and "Premium Telephone Preperation". Went to pair my phone with it. It sees and identifies my Huawei P10 phone (although the VW bluetooth doesn't appear on my phone when it searches). I click on it to connect and after a while it comes back and says "phone not compatible". I tried the same thing with a friends iphone 6 and I get the same problem. Now, I don't want to go back to an old phone just to have handsfree in the car, so I wondered if I can just change the bluetooth module or upgrade the firmware on the module. The module fitted is a novero part number 5N0 035 730 C. Attached is a…
-
- 1 reply
- 1.3k views
-
-
Does anyone know where I can find the paint code for my 2013 Beetle, cheers.
-
- 2 replies
- 1.8k views
-
-
Hi all new here just wanted to know how I can get Android auto which I believe is a free open source thing from Google on my Passat without paying VW dealer £250 for installing it!!! Would really appreciate some help👍👍
-
- 1 reply
- 1.5k views
-
-
Hi folk, I'm hoping someone hre can help me solve this problem... I need to change the OSF/Drivers side wishbone/suspension subframe/bracket. The problem I'm having is with the bolt to the steering rack! It has no nut on it just like a thing washer on the top with a small amount of thread sticking out. When I try to remove this bot it just turns including the thick washer on the top it all turns but dose not come out!!!! I'm at my wits end with it was in the pit all day yesterday trying to get it out cant get a grip on the washer type fixing on the top with anything. Am I doing something wrong? I've never even seen this set…
-
- 1 reply
- 1.5k views
-
-
Hi help or advice needed please . I have a issue regarding the timing pulleys on golf mk7 2013 1.2 tsi it is the belt version. Neither of which seem to have any timing notches ive inspected them on numerous occasions and was wondering if the timing kit that is required automatically times both the pulleys once fitted. Any help would be gratefully recieved regards
-
- 0 replies
- 1.3k views
-
-
Hi new to group,viewed a 57 plate shuttle but I noticed the dpf had been bypassed.Im no mechanic but is this a big no no.Guy selling said garaged had removed a smoking? Any advice ?
-
- 1 reply
- 1.5k views
-
-
Hi there, new to this group. I purchased some new Xenon bulbs from https://xenons4u.co.uk/. One of my bulbs broke, so I bought some new bulbs from https://xenons4u.co.uk/. Top quality and speedy delivery time. If anyone is looking to buy some new bulbs, I highly recommend using them.
-
- 0 replies
- 2.3k views
-