Jump to content
View in the app

A better way to browse. Learn more.

Volkswagen Owners Club - UK

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

Volkswagen Owners Club

Administrators
  • Joined

  • Last visited

Everything posted by Volkswagen Owners Club

  1. Hi Dazzer, good to see you back again Just wondering what equipment you have used to read the fault codes and whether it has the function to recode injectors As is common with Fords, the injectors go out of synch over time (usually 80k miles) and if you have the facility to recode them to recalibrate the injection rate which balances all of the injectors to the same rate....it seems like the issue is spreading across the engine hence my thought here? Alternatively, what is the coolant sensor reading (linear from cold to hot without any glitches?) May not necessarily bring up a code but can affect the injection rate as the engine warms up
  2. Hi....welcome to the Forum Firstly, the corrosion sounds like the tester being vigilant and listing these areas of corrosion as it is relevant and can therefore be checked the year after to see if it has worsened. Mostly, something like Lanolin based rust inhibitor could be sprayed into and onto the areas to ensure it doesn't get any worse. The service parts are a must and cannot be delayed if you wish to get to 200k miles. If you are not sure if something has been replaced then always best to replace it anyway Good luck with it all and let us know how you get on with it all
  3. Quite a few available from EuroCarParts - they're all quite good really
  4. Could be immobiliser, starter motor, crankshaft sensor or so many other potential causes. It really does need specialist diagnosis rather than some of the guesswork that has been carried out so far. Granted you have to start somewhere but after considerable expense and still not sorting the issue I can imagine you are rather disappointed. I would try to work out when the issue occurs: hot, cold, wet, dry, near a mast (it does happen with EMF swamping ECU's), clutch not depressed enough - just simple checks to eliminate the obvious
  5. That sounds like a safety issue and one which then manufacturers / dealers should address if it affects engine power or cutting out
  6. You could see if the cracking is only superficial or deep and may benefit from rubbing back with fine 1200 grit wet and dry to see if this removes it and then use T-Cut to bring to a high polish
  7. There is quite a bit of information on the relay here https://www.google.com/search?q=relay+185+on+vw+sharan&rlz=1C5CHFA_enGB830GB831&oq=relay+185+on+vw+sharan&aqs=chrome..69i57j33i160l2j33i22i29i30l2.9768j0j7&sourceid=chrome&ie=UTF-8
  8. There must be some specialist companies out there with parts being remade but otherwise try eBay for secondhand parts https://www.ebay.co.uk/b/bn_1838652?mkcid=1&mkrid=710-53481-19255-0&siteid=3&campid=5338906902&customid=&toolid=20012
  9. There is no fuse for the sensor Sometimes if there is an issue with the MAF and you unplug and it runs better (default running setting) then it proves the MAF is faulty. If it made no difference when it was unplugged then chances are its fine Do a scan of the ECU fault code memory to see what codes are stored in there (if any) Beyond that then proper diagnosis of the engine is required
  10. I know this happens on the Seat Leon which shares the same mechanicals as the VW The issue may be the plastic guide on the pedal has a ratchet that self-adjusts the cable and it fails Usually you can lift the pedal with your foot underneath and it works for a while until it goes again
  11. Sounds like the motor is failing but also check the resistor pack to see if there is corrosion on the terminals
  12. Sounds like an air leak could be causing these issues, check the intake and exhaust for leaks first
  13. Sounds like something has detached from the force of lurching forwards.....check the battery terminals and leads to see they are intact
  14. I would clarify this with the dealer in writing as a number of new vehicles off the line are being delivered with less electronic options than originally agreed owing to the semi-conductor shortages. Typical example is the keyless entry fobs being reduced from the standard two to just one when you collect it
  15. The first thing to do is check the battery voltage when the light comes on e.g. is it overcharging (above 14.5 volts maximum) when it goes above 2000 rpm If so, then maybe the wrong alternator If not then check all earths to the engine are in place and not disconnected or broken. Otherwise last thing would be to check the over-running pulley is working okay (eg. only rotating one way and locking the other direction. If not then replace it with a new one
  16. Engine or gearbox mounts and stabilisers? Driveshaft joints? Subframe mounts?
  17. I would stick to the genuine oils recommended by the manaufacturer Any VW dealership should be able to provide the oil but probably wont be cheap though
  18. Battery condition? Maybe reset the electrical system by disconnecting the battery (negative terminal) for about 15 mins then reconnect and see if it resets Make sure you have radio code beforehand
  19. Hi Dave.....welcome to the Club! Long line of VW's over the years then Good to have you onboard!
  20. If in doubt, get it changed, its sometimes only delaying the inevitable replacement and puts your mind at ease
  21. I wonder if the flywheel/flexplate or crank sensor toothed wheel may have the incorrect number of teeth which can happen with engine changes Alternatively, maybe worth having the standard Map loaded onto the ECU to eliminate that as a potential source of the issue?
  22. I believe you should try to sell it as a Spare or Repairs car as they are getting more sought after now the Mk4 is becoming rarer to find Feel free to post up more specs and pics if you want?
  23. Oh goodness that is a mixed bunch of faults As you say, my first thoughts were wiring issues. I would start at the battery terminals and leads including the all important earth leads and connections and go from there. If you can get it running then do a 'wiggle test' which is wiggling any wires and connections to invoke the fault and bingo there is your problem area Let us know what you find
  24. There are a few options if no one can help on here If you type in the search term Volkswagen SVM and see what comes up that may be of use to you
  25. Nice mods and you certainly know what look you're after which is great

Account

Navigation

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.